Storage - Simplicity 1695875 Operator's Manual

Storage

WARNING
Fuel and its vapors are extremely flammable
and explosive.
Fire or explosion can cause severe burns or
death.
When Storing Fuel or Equipment with Fuel in Tank
ÊÅÈ» ·Í·Ï ¼ÈÅà ¼ËÈÄ·¹»É ÉÊÅÌ»É Í·Ê»È ¾»·Ê»ÈÉ ÅÈ Åʾ»È
appliances that have pilot lights or ignition sources because
they can ignite fuel vapors.
Fuel System
Fuel can become stale when stored over 30 days. Stale
fuel causes acid and gum deposits to form in the fuel
system or on essential carburetor parts. To keep fuel fresh,
use Briggs & Stratton® Advanced Formula Fuel Treatment
& Stabilizer, available wherever Briggs & Stratton genuine
service parts are sold.
For engines equipped with a FRESH START® fuel cap,
use Briggs & Stratton FRESH START® available in a drip
concentrate cartridge.
There is no need to drain gasoline from the engine if a
fuel stabilizer is added according to instructions. Run the
engine for 2 minutes to circulate the stabilizer throughout
the fuel system before storage.
Engine Oil
While the engine is still warm, change the engine oil.
en
Snowthrower
1. Thoroughly clean the snowthrower.
2. Lubricate all lubrication points (see authorized dealer).
3. Make sure all nuts, bolts, and screws are securely
fastened. Inspect all visible moving parts for damage,
breakage, and wear. Replace if necessary.
4. Touch up all rusted or chipped paint surfaces.
5. Cover the bare metal parts of the auger and impeller
with rust preventative.
6. If possible, store your snowthrower indoors and cover it
to protect from dust and dirt.
7. On models with folding handles, loosen the knobs that
secure the upper handle. Rotate the upper handle
forward.
8. If stored outdoors, place the snowthrower on blocks and
ensure the entire machine is off the ground. Cover the
snowthrower with a heavy tarpaulin.
Remove from Storage
1. Raise the upper handle to the operating position and
tighten the knobs that secure the upper handle.
2. Fill the fuel tank with fresh fuel.
3. Check the spark plug. Make sure the gap is correct. If
the spark plug is worn or damaged, replace.
4. Make sure all fasteners are tight.
5. Make sure all guards, shields, and covers are in place.
Storage
21