Table of Contents
Advertisement
Boot Device Options
This option shows the target ID of the device you are booting from. The default
setting is 0 (zero).
operating systems will not run unless the boot device is set at zero.
The figure below shows the Boot Device Options screen.
Configuration
SCSI Bus Interface Definitions
Additional Options
Select SCSI peripherals from which to boot
To view peripherals by ID# select "SCSI Disk Utilities" from previous menu
Boot Channel...............................................................................
Boot SCSI........................................................................0
-----------Options Listed Below Have NO EFFECT if Multiple Lun Support is Disabled------------
Boot Lun Number ........................................................................ 0
Arrow keys to move cursor, <Enter> to select option, <Esc> to exit (
Figure 4-7 Boot Device Options Screen
Altos 1100E Series User's Guide
We recommend that you not change this setting.
Adaptec AHA-3950U2B
AHA-3950U2B at Bus:Device 00:00h
Host Adapter SCSI ID................................ 7
SCSI Parity Checking ................................ Enabled
Host Adapter SCSI Termination................. Low ON/High ON
Boot Device Configuration
Boot Device Options .................................. Press <Enter>
SCSI Device Configuration ........................ Press <Enter>
Advanced Configuration Options ............... Press <Enter>
<F6> - Reset to Host Adapter Defaults
SCSISelect (TM)
Some
Utility
A First
=default)
*
Advertisement
Table of Contents
