Configure/View Host Adapter Settings Screen (2 Of 2); Host Adapter Scsi Id - Acer ALTOS 1100E Series User Manual

Configuration
SCSI Bus Interface Definitions
Additional Options
Arrow keys to move cursor, <Enter> to select option, <Esc> to exit (
Figure 4-3 Configure/View Host Adapter Settings Screen (2 of 2)
Use the cursor (
menu of choices or to make selections. Press Esc at any time to return to the
previous menu.

Host Adapter SCSI ID

This option allows you to change the host controller SCSI ID. The figure below
shows the available IDs for use with the AHA-3950U2B. The default setting is
SCSI ID 7. (We recommend that you not change this setting.) Some operating
system software will not run unless the SCSI controller ID is set at ID 7.
Altos 1100E Series User's Guide
Adaptec AHA-3950U2B
AHA-3950U2B at Bus:Device 00:00h
Host Adapter SCSI ID................................ 7
SCSI Parity Checking ................................ Enabled
Host Adapter SCSI Termination................. Automatic
Boot Device Options .................................. Press <Enter>
SCSI Device Configuration ........................ Press <Enter>
Advanced Configuration Options ............... Press <Enter>
<F6> - Reset to Host Adapter Defaults
) to move to your selection. Press Enter to display a pop-up
Press F6 to reset all settings to the SCSI
controller defaults. SCSI controller default
settings are marked with an asterisk (*)
throughout the selection submenus.
SCSISelect (TM) Utility
=default)
*