Table of Contents
Advertisement
1.7
Installing and Removing a Hot-swappable
Redundant Power Supply Module
The power subsystem consists of two hot-swappable power supply module bays
that allows the installation of two 337-watts power supply modules in a hot-
swappable redundant configuration. A redundant power configuration enables a
fully-configured system to continue running even if one power supply fails.
To install a hot-swappable redundant power supply:
1.
Insert the power supply into the housing. The metal lock will click into place
when the power supply is fully installed in the housing.
Metal Lock
2.
Secure the power supply with a thumbscrew.
The system housing comes with one hot-
swappable redundant power supply installed.
Make sure that the power supply is properly
inserted, as shown in the figure above.
Chapter 1 – System Housing 1-21
Advertisement
Table of Contents
