Table of Contents
Advertisement
Serial port 2, 3-7, 3-24
Setup password, 3-41, 3-42, 3-43
Silent boot, 3-19
Software error messages, 2-26
Stand-alone system, 1-1
Start unit request failed, 4-25
Startup configuration, 3-18
Boot from IDE CD-ROM, 3-20
Fast POST mode, 3-18
Initialize SCSI before IDE, 3-19
Memory test, 3-19
Num lock after boot, 3-19
Silent boot, 3-19
System boot drive, 3-20
System BIOS ID, 3-9
System BIOS version, 3-9
System board, 2-1
ASM pro, 2-24
Error messages, 2-26
Features, 2-1
Front panel connectors, 2-9
Heatsink, installing and removing,
2-13
Installing expansion cards, 2-22
Installing components, 2-10
Installing the termination board, 2-
18
Jumpers and connectors, 2-5
Major components, 2-3
Memory upgrade, 2-19
Pentium III processor, installing, 2-
15
Pentium III processor, removing,
2-17
Remote diagnostic management, 2-
25
System board layout, 2-4
System boot drive, 3-20
System error messages, 2-26
System event configuration, 3-36
System housing, 1-1
Expansion board, installing, 1-24
Features, 1-2, 1-25
Hot-swap cages, installing, 1-11
Hot-swappable redundant power
supply module, installing and
removing, 1-21
Housing panels, opening, 1-5
Installing and removing a hot-
swappable redundant power
supply module, 1-21
Installing drives, 1-7
Internal structure, 1-4
Replacing the external redundant
system fan, 1-23
SCSI backplane board, 1-25
Stand-alone system, 1-1
System information, 3-3
Bus frequency, 3-5, 3-35
External cache, 3-5
Floppy drive A, 3-5
Floppy drive B, 3-5
IDE primary channel master, 3-6
IDE primary channel slave, 3-6
IDE secondary channel master, 3-6
IDE secondary channel slave, 3-6
Internal cache, 3-5, 3-33
Memory parity mode, 3-7
Onboard USB, 3-7, 3-28
Parallel port, 3-7, 3-25
Pointing device, 3-7
Processor, 3-4
Processor speed, 3-5, 3-35
Serial port 1, 3-7, 3-23
Serial port 2, 3-7, 3-24
Total memory, 3-6
Index 5
Advertisement
Table of Contents
