Primary & Secondary Master/Slave - Fujitsu D1271 Technical Manual

4.3.1 Primary & Secondary Master/Slave
NOTE: Before attempting to configure a hard disk drive, make sure you
have the configuration information supplied by the drive manufacturer.
Incorrect settings may cause the system to fail to recognize the installed
hard disk. To allow the BIOS to detect the drive type automatically, select
[Auto].
Type [Auto]
Select [Auto] to automatically detect an IDE hard disk drive. If automatic
detection is successful, Setup automatically fills in the correct values for
the remaining fields on this sub-menu. If automatic detection fails, this
may be because the hard disk drive is too old or too new. Try updating the
BIOS or manually entering the IDE hard disk drive parameters.
NOTE: After entering the IDE hard disk drive information into BIOS,
use a disk utility, such as FDISK, to partition and format new IDE hard
disk drives. This is necessary so that you can write or read data from the
hard disk. Make sure to set the partition of the Primary IDE hard disk
drives to active.
Other options for the Type field are:
[None] - to disable IDE devices
D1271/D1291 CUV-LSV/CUV-LV User's Manual
4. BIOS SETUP
49