Fujitsu D1271 Technical Manual page 48

7. The utility starts to program the new BIOS information into the flash ROM. The boot block will be
updated automatically only when necessary. This will minimize the chance that a failed update will
prevent your system from booting up. When the programming is finished, Flashed Successfully will
be displayed.
Flash Memory: Winbond W29C020 or SST 29EE020 or Intel 82802AB
BIOS Version
[Current ]
[test.awd]
BIOS Mode
[Current ]
[test.awd]
Date of BIOS Built
[Current ]
[test.awd]
Check sum of 1001.010 is F266.
Are you sure (Y/N) ? [Y]
Block Erasing –- Done
Programming
Flashed Successfully
Press ESC To Continue
8.
Follow the onscreen instructions to continue.
Copyright (C) 1994-99, ASUSTeK COMPUTER INC.
Flash Memory: Winbond W29C020 or SST 29EE020 or Intel 82802AB
Current BIOS Version: ASUS XXX-XX ACPI BIOS Revision 100X
BIOS Model
BIOS Built Date
Choose one of the followings:
1. Save Current BIOS To File
2. Update BIOS Including Boot Block and ESCD
Enter Choice: [1]
You have flashed the EPROM, It is recommended that you turn off
the power, enter SETUP and LOAD Setup defaults to have CMOS
updated with new BIOS when exits.
Press ESC To Exit
WARNING! If you encounter problems while updating the new BIOS, DO NOT turn off your system
since this might prevent your system from booting up. Just repeat the process, and if the problem
still persists, update the original BIOS file you saved to disk above. If the Flash Memory Writer utility
was not able to successfully update a complete BIOS file, your system may not be able to boot up.
If this happens, your system will need servicing.
44
4. BIOS SETUP
Update BIOS Including Boot Block and ESCD
ASUS XXX-XX ACPI BIOS Revision 100X
ASUS XXX-XX ACPI BIOS Revision 100X
XXX-XX
XXX-XX
09/25/99
05/29/00
-- 3FFFF
ASUS ACPI BIOS
FLASH MEMORY WRITER V1.24
: XXX-XX
: 09/25/99
D1271 / D1291 CUV-LSV / CUV-LV User's Manual