Specifications - Dremel 8200 Original Instructions Manual

ENVIRONMENT
DISPOSAL
ONLY FOR EC COUNTRIES
Do not dispose of power tools into household
waste!
Waste Electrical and Electronic Equipment and its
implementation into national right, power tools
that are no longer usable must be collected
separately and disposed of in an environmentally
correct manner.

SPECIFICATIONS

GENERAL SPECIFICATIONS
Voltage Rating . . . . . . . . . 10,8 V
Amperage Rating . . . . . . 1,3 – 2,0 Ah
. . . . . . . . . . n 33000 min
Collet Capacity . . . . . . . . 0,8 mm, 1,6 mm, 2,4 mm,
3,2 mm
SPECIFICATIONS CHARGER
Input. . . . . . . . . . . . . . . . . 230 V, 50 – 60 Hz, 26 W
Output . . . . . . . . . . . . . . .
EXTENSION CORDS
Use completely unrolled and safe extension cords with a
capacity of 5 Amps.
ASSEMBLY
BATTERY CHARGE CONDITION INDICATOR LIGHTS
Your tool is equipped with charge condition indicator
condition of the battery.
3 "side to side" lights – battery charge is too low to run
tool. Recharge the battery.
and let battery cool down.
Your tool is equipped with advanced electronics that
excessive operating temperature and/or current draw. If
the warning symbol illuminates red and/or the tool stops
working during heavy use, this most likely indicates that the
and the battery pack should either be changed or allowed
to cool to ambient temperature before continuing use. If the
tool automatically turns off due to overload conditions, the
DV-2610Z03933, Page: MUL (VAD), downloaded at: 2016.05.13_09:03:51, by PT-RT/MKT-AP_Echo.ZHANG
switch must be turned off for a few seconds to allow the
circuit to reset before continuing use.
IMPORTANT CHARGING NOTES
1.
only when the battery temperature is between 32°F
or too cold, the charger will not fast charge the battery.
automatically begin charging.
2. A substantial drop in operating time per charge may
mean that the battery pack is nearing the end of its life
and should be replaced.
3. Remember to unplug charger during storage period.
NOTE: Use of chargers or battery packs not sold by
CHARGING BATTERY PACK (MODEL 875)
With no battery pack inserted, the charger's green indicator
power and the charger is ready for operation.
When you insert the battery pack into the charger, the
indicates that the battery is receiving a fast charge.
A.
Charger
, 1,5 A C.
battery pack is fully charged and can be removed from the
charger.
When you begin the charging process of the battery pack,
a steady green light could also mean the battery pack is
too hot or too cold.
Fast charging is only possible when the temperature range
of the battery pack is between 0°C and 45°C.
When needed, the internal fan of the charger will turn on to
aid the charging process and speed.
As soon as the battery pack reaches the correct
temperature range, the battery charger will automatically
switch to fast charging.
blinking depending on temperature.
if the battery pack was not completely discharged.
If the green indicator light is "ON", the battery pack cannot
accept a charge.
wide range of Dremel accessories and attachments allow
such as sanding, carving, engraving, routing, cleaning and
polishing.
A.
On/Off switch
C. Hanger
21
GENERAL