Dremel 8200 Original Instructions Manual page 22

D.
E. Variable speed switch
F.
H. Ventilation openings
I. Housing
J.
K.
L.
M.
N. Collet nut
O. Collet
Collet wrench
COLLETS
with various shank sizes. Four size collets are available to
accommodate the different shank sizes. Collet sizes are
A. Collet nut
C.
D.
E.
F.
NOTE: Some multitool kits may not include all four collet
Always use the collet that matches the shank size of the
accessory you plan to use. Do not force a larger diameter
shank into a smaller collet.
CHANGING COLLETS
A. Collet wrench
C. Collet nut
D.
E.
1.
shaft by hand until it engages the shaft lock. Do not
engage the shaft lock button while multitool is running.
2. With the shaft lock button engaged, loosen and remove
the collet nut. Use the collet wrench if necessary.
3. Remove the collet by pulling it free from the shaft.
4. Install the appropriate size collet fully into the shaft and
the nut when there is no bit or accessory installed.
CHANGING ACCESSORIES
1.
hand until it engages the shaft lock. Do not engage the
2.
necessary.
3. Insert the bit or accessory shank fully into the collet.
4.
collet nut until the bit or accessory shank is gripped by
the collet.
NOTE: Be sure to read the instructions supplied with your
Use only Dremel tested, high performance accessories.
DV-2610Z03933, Page: MUL (VAD), downloaded at: 2016.05.13_09:03:51, by PT-RT/MKT-AP_Echo.ZHANG
EZ TWIST™ INTEGRATED WRENCH/NOSE CAP
F.
loosen and tighten the collet nut without the use of the
standard collet wrench.
1.
insert on inside of the cap with the collet nut.
2. With the shaft lock engaged twist nose cap counter
clockwise to loosen the collet nut. Do not engage the
shaft lock button while multitool is running.
3. Insert the bit or accessory shank fully into the collet.
4. With the shaft lock engaged twist nose cap clockwise
to tighten the collet nut.
5.
NOTE: Be sure to read the instructions supplied with
your Dremel accessory for further information on its
Use only Dremel tested, high performance accessories.
BALANCING ACCESSORIES
For precision work, it is important that all accessories
slightly loosen collet nut and give the accessory or collet
You should be able to tell by the sound and feel if your
accessory is running in balance. Continue adjusting in this
fashion until best balance is achieved.
USE
GETTING STARTED
Hold it in your hand and feel its weight and balance. Feel
grasped much like a pen or pencil.
Always hold the tool away from your face. Accessories
they come up to speed.
When holding tool, do not cover the ventilation
openings with your hand. Blocking the ventilation
openings could cause the motor to overheat.
your multitool will perform best by allowing the speed,
along with the correct Dremel accessory and attachment,
to do the work for you. Do not put pressure on the
tool during use, if possible. Instead, lower the spinning
accessory lightly to the work surface and allow it to touch
the point at which you want to begin. Concentrate on
guiding the tool over the work using very little pressure
from your hand. Allow the accessory to do the work.
Usually it is better to make a series of passes with the tool
rather than to do the entire job with one pass. A gentle
touch gives the best control and reduces the chance of
error.
HOLDING THE TOOL
For best control in close work, grip the multitool like a
22