Engine
Starter gear rim
- Check the toothing is level and in good conditions
Intermediate gear
- Check that the keying toothing on the crown and
the starter motor are in good conditions.
- Check that the bendix opens and returns ade-
quately.
Refitting the flywheel magneto
- Refit the stator and the pick-up being careful to
pass the wiring through the appropriate crankcase
couplings.
- Refit the flywheel to the crankshaft being careful
to respect the keying, then lock rotation with the
specific tool and tighten the nut to the prescribed
torque.
N.B.
A VARIATION OF THE AIR GAP DISTANCE CAN LEAD TO
A VARIATION IN THE IGNITION ADVANCE SUCH AS TO
CAUSE PINGING, KNOCKING ETC.
Specific tooling
020565Y Flywheel lock calliper spanner
Locking torques (N*m)
Flywheel nut
52 ÷ 58
ENG - 82
LX 4T USA