Starter Motor Screws - VESPA LX 4T USA Workshop Manual

LX 4T USA
Refitting the starter motor
- Install the starter motor in its seating in the crank-
case.
- Tighten the screw on the head side but do not
lock it, screw the second screw inserting the earth
cable (black), then tighten the 2 screws at the pre-
scribed torque.
- Tighten the locking screw of the positive cable
(red) on the side contact.
N.B.
REFIT THE REMAINING PARTS AS DESCRIBED IN THE
CYLINDER HEAD, TIMING, LUBRICATION, FLYWHEEL
AND TRANSMISSION CHAPTERS.
Locking torques (N*m)

Starter motor screws

Cylinder assy. and timing system
Removing the rocker-arms cover
- Remove the cooling covers
- Remove the 4 retainers of the tappet cover
- Remove the cover and the O-ring
- Remove the 4 screws and then remove the Blow-
by cover
- Clean the nozzle labyrinth and the membrane
(replace it, if necessary), then remove the cover
unit.
11 ÷ 13
Engine
ENG - 83