VESPA LX 4T USA Workshop Manual page 57

LX 4T USA
- If the above tests have positive results, jump the
contacts 5 (blue/black) and 3 (white) on the con-
nector, set the key switch to ON and the turn
indicator switch left and right to see when the lights
are steadily on (as they are powered directly from
the battery).
If even after this operation the turn indicators fail
to turn on, check that the wiring is not damaged
and the switch works properly. If these last two
tests have a positive result, replace the regulator
because it is certainly not functioning properly.
Specific tooling
020331Y Digital multimeter
Sealed battery
INSTRUCTIONS FOR REFRESHING THE STOCK CHARGE OF AN OPEN CIRCUIT
1) Voltage check
Before installing the battery on the vehicle, check the open circuit voltage with a normal tester.
- If the voltage exceeds 12.60 V, the battery may be installed without any renewal recharge.
- If voltage is below 12.60 V, a renewal recharge is required as explained in 2).
2) Constant voltage battery charge mode
-Constant voltage equal to 14.40÷14.70V
-Initial charge voltage equal to 0.3÷0.5 for nominal capacity
-Duration of the charge: 10 to 12 h recommended
Minimum 6 h
Maximum 24 h
3) Constant current battery charge mode
-Charge current equal to 1/10 of the nominal capacity of the battery
-Duration of the charge: 5 h
WARNING
-WHEN THE BATTERY IS REALLY FLAT (WELL BELOW 12.6V) IT MIGHT BE THAT 5 HOURS OF
RECHARGING ARE NOT ENOUGH TO ACHIEVE OPTIMAL PERFORMANCE.
IN THESE CONDITIONS IT IS HOWEVER ESSENTIAL NOT TO EXCEED EIGHT HOURS OF CON-
TINUOUS RECHARGING SO AS NOT TO DAMAGE THE BATTERY ITSELF.
Dry-charge battery
WARNING
- Battery electrolyte is toxic and it may cause serious burns. It contains sulphuric acid. Avoid contact
with eyes, skin and clothing. In case of contact with eyes or skin, flush abundantly with water for about
15 minutes and seek immediate medical attention.
Electrical system
ELE SYS - 57