Air Filter - VESPA LX 4T USA Workshop Manual

Maintenance
Check
- Place the vehicle on the stand on level ground.
- Unscrew oil dipstick «A», wipe it with a clean rag,
reinsert it and screw it in fully.
- Pull out the dipstick and check that the oil level is
in the middle (two-notch dipstick) or reaches the
middle notch (three-notch dipstick).
- Reinsert the dipstick and screw it in fully.
Recommended products
AGIP ROTRA 80W-90 rear oil hub
SAE 80W/90 Oil that exceeds the requirements of
API GL3 specifications
Replacement
- Remove oil filler cap/dipstick «A».
- Unscrew the drain plug «B» shown in the figure
and allow the oil to drain out.
- Retighten the drain plug and fill the hub with oil
(about 100 cc).

Air filter

After removing the lower part of the left-hand side
cover, unscrew the four fixing screws and the two
knobs (which are exposed by overturning the sad-
dle and removing the helmet compartment), re-
move the filter cover and then pull out the filter
cartridge.
Cleaning:
-Wash the filter with soap and water.
-Dry with a clean cloth without wringing and with
compressed air.
-Soak with a 50% fuel-oil mixture.
MAIN - 32
LX 4T USA