VESPA LX 4T USA Workshop Manual page 129

LX 4T USA
Suspensions
- Fit both dust guard rings «C» on the swinging hub
as shown in the detail drawing «A».
- Connect the swinging hub to the steering tube
with the guide pin, part 5*.
- Use the specific tool fitted with part 3* on its stem
and with part 4 at the bottom of the tool.
- Insert the previously greased pin on the swinging
hub and with the tool handgrip, move part 3 until it
stops on the steering tube.
- After fitting the pin, insert the two spacers, part
17*, slightly hitting with the mallet.
* Supplied with the tool
Specific tooling
020021Y Front suspension service tool
Recommended products
AGIP GREASE PV2 Grease for control levers
on the engine
White anhydrous-calcium based grease to protect
roller bearings; temperature range between -20 °
C and +120 °C; NLGI 2; ISO-L-XBCIB2
- Use the specific tool, fitted with part 1*, and op-
erate the handgrip until the pin and the Nadella are
simultaneously ejected in the direction opposite
the tool thrusting force.
- To eject the second Nadella, use the tool fitted
with part 2* instead of part 1, on the side opposite
the one shown in the figure.
* Supplied with the tool
Specific tooling
020021Y Front suspension service tool
SUSP - 129