Advertisement
R
hank you for your purchase of this Elcometer 106 Pull Off Adhesion Tester. Welcome to Elcometer.
T
Elcometer are world leaders in the design, manufacture and supply of inspection equipment for coatings
and concrete. Our products cover all aspects of coating inspection, from development through application
to post application inspection.
The Elcometer 106 Pull Off Adhesion Tester is a world beating product. With the purchase of this product
you now have access to the worldwide service and support network of Elcometer. For more information visit
our website at www.elcometer.com
1 ABOUT YOUR TESTER
The Elcometer 106 Pull Off Adhesion Tester is designed to measure the bond strength of applied coatings.
A wide range of coatings can be tested including paint, plastic, sprayed metal, epoxy, wood veneers,
laminates on wood, metal or plastic.
The Adhesion Tester employs a pull-off method to measure the force required to pull an area of coating
away from the base material.
The surface under examination is prepared and then a test dolly is attached by adhesive. When the
adhesive is cured the Adhesion Tester claw is engaged onto the dolly and a force is applied by tightening
a wheel/nut on the top of the tester. The force is recorded by means of a dragging indicator on an engraved
scale. The indicator retains the value at which the dolly and the coating separate from the surface.
There are five different ranges available. Each range is expressed in imperial and metric units and is directly
related to the area of the standard dolly.
2
Advertisement
