System Board Hook - HP 14-ck0 Series Maintenance And Service Manual

System board hook

Description
System board hook
NOTE: Located under the battery, a black plastic piece fits around the screw boss next to the memory
modules. This "hook" is unsecured and can fall out if you tilt the computer. Use the following image to
determine where the hook is properly installed.
Before removing the system board hook, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the bottom cover (see
5. Remove the battery (see
Remove the system board hook:
▲ Remove the system board hook from the computer.
Reverse this procedure to install the system board hook.
Bottom cover on page
Battery on page 31).
29).
Component replacement procedures
Spare part number
L23206-001
39