Dc Amps: <600A - Jaw; Non-Contact Voltage - UEi DL489 Instruction Manual

• Do not attempt to measure more than 600A DC.
Features:
RANGE
Range
60A 0.01A
600A 0.1A
Minimum current for Clamp measurement: 0.3A
NCV Sensor in the tip.
• Press and hold the NCV button and move the tip of the clamp meter near
voltage source.
• Non-Contact Voltage Detection is used to detect power with sensor located
in the tip of the clamp head, indicates positive response with both an
Audible and Visual alert.
• Do not use Non-contact voltage detector to determine if there is current on
the wire. Detection operation could be affected by socket design, insulation
thickness, type or other factors.
• Voltage indictor light may also light when voltage (>AC/DC 30V) is present
on the meter's input jack or from an external interference such as motors,
flashlights, etc.
On Voltage
Approx. 24V AC
DC Amps: <600A
600V
NCV
MAX/
MIN
PEAK
DL489 True RMS
MAX/
MIN
HOLD
PEAK
Resolution

Non-Contact Voltage

CAT III
600A
RANGE
DC
Zero
INRUSH
T
1
30V
T
2
TEMP
CATII 1000V
CATIII
600V
MAX
Accuracy
±(2.0% +8 dgts)
CAT III
600V 600A
NCV RANGE
MAX/ DC
MIN Zero
INRUSH
PEAK
DL489 True RMS
T
1
30V
T
2
TEMP
CATII 1000V
CATIII
600V
MAX
8
• Default =
µA
• Press x1 =
• Press x2 =
µA
• Press and hold =
Overload Protection
600V RMS
(upper)
(lower)
(lower)
(upper)