Cisco DMP 4305G Getting Started Manual page 35

Procedure
Step 1 Click Basic in the Settings list.
Choose Disabled from the Dynamic IP Addressing (DHCP) list, and then:
Step 2
a. Enter in the IP Address field the static IP address that your DMP should use.
b. Enter in the Subnet Mask field the netmask that your DMP should use with its static IP address.
c. Enter in the Default Gateway field the network gateway that your DMP should use with its static
IP address.
d. Enter in the Primary DNS Server field the DNS server that your DMP should use with its static
IP address.
Will a network address translation (NAT) service give your DMP a private IP address? If so:
Step 3
Choose Yes from the Using NAT list.
a.
b. Enter in the NAT IP Address field the 1-to-1 public address (which is configured on the local router)
that corresponds to the private IP address.
Click Apply.
Step 4
Step 5 Click Save Configuration in the Administration list, and then click Save.
Step 6 Click Restart DMP in the Administration list, and then click Restart.
Ship or deliver the DMP to its deployment site, and then:
Step 7
Connect it to its presentation system.
a.
Connect it to its local network segment.
b.
Connect it to its power source.
c.
Stop. You have completed this procedure.
Step 8
Related Topics
Prepare Your DMP to Use a Static IP Address Over Ethernet, page 32
•
78-19212-02
Getting Started Guide for Cisco Digital Media Players
Configure Settings
35