Connect Equipment
Use an HDMI Connection
Timesaver
Is your display a touchscreen? If so, you can this topic. Instead, see the
Procedure
Connect the HDMI cable to the HDMI interface on the back panel of your DMP.
Step 1
Connect the other end of the cable to your presentation system.
Step 2
Turn On the presentation system.
Step 3
Stop. You have completed this procedure.
Step 4
Related Topics
•
•
Use a Connection that Combines HDMI with DVI
Timesaver
Is your display a touchscreen? If so, you can ignore this topic. Instead, see the
HDMI and DVI differ in their support for audio signals and use connectors that are shaped differently,
but otherwise are identical. Thus, an adapter can help you to connect to your DMP any presentation
system that supports DVI but not HDMI. When you do this, however, you must also use a separate signal
cable to transmit audio signals, or there will not be any audio.
Before You Begin
•
Procedure
Make connections for video.
Step 1
a.
b.
c.
Step 2
Make connections for audio.
a.
b.
Getting Started Guide for Cisco Digital Media Players
26
Physical Interfaces (I/O Ports), page 12
Use a Connection that Combines HDMI with DVI, page 26
Obtain an HDMI-to-DVI adapter.
Connect the HDMI cable to the HDMI interface on the back panel of your DMP.
Fasten an HDMI-to-DVI adapter to the free end of the cable.
Connect the free end of the DVI adapter to the corresponding interface on your presentation system.
Plug the 3.5mm audio jack into the Audio interface on the back panel of your DMP.
Connect the other end of the audio cable to the corresponding interface on your presentation system.
"Connect to a Touchscreen" section on page
"Connect to a Touchscreen" section on page
27.
27.
78-19212-02