Start Here - Cisco DMP 4305G Getting Started Manual

Start Here

Start Here
•
•
•
Important Safety Warnings
Warning IMPORTANT SAFETY INSTRUCTIONS
This warning symbol means danger. You are in a situation that could cause bodily injury. Before you work on
any equipment, be aware of the hazards involved with electrical circuitry and be familiar with standard
practices for preventing accidents. Use the statement number provided at the end of each warning to locate its
translation in the translated safety warnings that accompanied this device. Statement 1071
SAVE THESE INSTRUCTIONS
Read the installation instructions before connecting the system to the power source. Statement 1004
The device is designed to work with TN power systems. Statement 19
The power supply must be placed indoors. Statement 331
This equipment is intended to be grounded. Ensure that the host is connected to an earth ground during normal
use.
When installing the unit, always make the ground connection first and disconnect it last.
Use only the Cisco-supplied combination of power cord, plug, and adapter — if any — that shipped with the
equipment, or which you ordered separately. Otherwise, if you use other such supplies, including similar
supplies that Cisco might sell for use with similar equipment, you:
• Might damage or destroy data, equipment, or other property.
• Might cause any combination of electrical shock, electrical fire, injury, or loss of life.
• Will void the warranties for Cisco equipment.
Do not work on the system or connect or disconnect cables during periods of lightning activity. Statement 1001
This product relies on the building's installation for short-circuit (overcurrent) protection. Ensure that the
protective device is rated not greater than: 120 VAC, 15A U.S. (240 VAC, 10A international)
The plug-socket combination must be accessible at all times, because it serves as the main disconnecting
device. Statement 1019
To avoid electric shock, do not connect safety extra-low voltage (SELV) circuits to telephone-network voltage
(TNV) circuits. LAN ports contain SELV circuits, and WAN ports contain TNV circuits. Some LAN and WAN ports
both use RJ-45 connectors. Use caution when connecting cables. Statement 1021
Installation of the equipment must comply with local and national electrical codes. Statement 1074
Ultimate disposal of this product should be handled according to all national laws and regulations.
Getting Started Guide for Cisco Digital Media Players
2
Important Safety Warnings, page 2
Cisco DMS Overview, page 3
Plan and Prepare, page 7
78-19212-02