Cisco DMP 4305G Getting Started Manual page 31

Procedure
Step 1 Click Wireless Configuration in the Settings list.
Tip
Choose Enabled from the Wireless Interface list.
Step 2
Each 802.11 wireless network is assigned a name to distinguish it from other networks. The technical
term for this network name is Service Set Identifier, or SSID.
Double-click the SSID for your network in the Detected Networks table.
Step 3
OR
When you do not see your SSID in the Detected Networks table, do the following.
Enter in the Network SSID field the SSID for your network.
a.
Choose from the Security list the security method for your network. Its options are:
b.
•
•
•
•
•
•
The security method that you choose controls, in part, which fields and options this DMPDM page
shows to you.
•
•
•
78-19212-02
Do you see this option in DMPDM? If not, your DMP might not support wireless networking. See
WEP-64bit
WEP-128bit
WPA-PSK
WPA-EAP
WPA2-PSK
WPA2-EAP
When you see the PSK field and you chose a WEP-based security method, enter in it the key
from which your 64-bit or 128-bit passphrase is cryptographically derived.
When you see the PSK field and you chose a WPA-based or WPA-2-based security method,
enter in it the pre-shared key for your network.
When you see the Encryption list, choose from it either TKIP or CCMP AES.
Getting Started Guide for Cisco Digital Media Players
Configure Settings
Table 2 on page 12.
31