ISSI LC-2 Operation Manuals page 15

Innovative Scientific Solutions, Inc.
2. Clear the list of IP addresses in the computer through the command prompt (shown
below):
Open the Command Prompt (Start > Search > cmd) as administrator:
Once the command prompt is open, type "arp –a" to display the IP address and Physical
Address of all devices on the local network.
To clear the table so the lens controller IP is reset to the new address entered, type "arp –d".
Running the lens control software as administrator will automatically clear the ARP table.
Always on Top makes the LC-2 software always appear as the front window for all windows
open on the desktop.
The save and load settings are used to save positions and recall them on each motor of the
lens. When the lens parameters are at their desired location, those positions on each motor
can be saved and later recalled. To save new settings, select Save Settings and enter a name
for those lens settings. Settings are saved to the computer in which the interface is open, not
the lens controller itself.
14