Table of Contents
Advertisement
Innovative Scientific Solutions, Inc.
If the toolbar is red, that means it is not a valid IP address. Type in the desired IP address and
click Apply to implement.
The new IP address will automatically be connected:
If the IP address does not change and the following message is displayed after the IP is
changed, it may need to be run as administrator.
When the IP address is changed, the software will automatically attempt to switch
communication to the new address. If it can't find that address, it is likely to be because the
IP address previously used is stored on the computer and needs to be cleared before the new
address can take hold. The timeout for this to occur by itself can sometimes be 10-20
seconds. To do this, there are two options:
1. Run the lens control software as the administrator
13
Advertisement
Table of Contents
Need help?
Do you have a question about the LC-2 and is the answer not in the manual?
Questions and answers