Download Print this page

Final Assembly - ETC Source Four jr Zoom Assembly Manual

Hide thumbs Also See for Source Four jr Zoom:

Advertisement

Final assembly

Note: Left and right designations
are your left and rights as you look
at the front (gel plane) of the unit.
Source Four jr / jr Zoom Assembly Guide
Tools required: Phillips head screwdriver.
1. Place the left barrel casting (1) face up on your work surface with
the colorframe end to your right.
2. If necessary, place spring (17) over post in right and left castings (1
and 2). Secure with clip (18).
3. Set shutter assembly into the shutter slot in left casting (1) with the
rounded side of the shutter handles facing right.
4. Install the short end of the gel retainer clip (5) in the left lens holder
casting (1).
5. Position clip (5) in the forward, locked position, then install the
retainer spring (8) on the clip.
6. Snap spring (7) onto reflector (6) and place assembly into left casting
(1) so that the front edge of the reflector is supported by spring (17)
and the spring (7) on the back rests in the left casting rear supports.
7. Gently set the right barrel casting (2) onto the left casting so that the
gel clip retainer, shutter assembly and reflector assembly fit into
their respective positions.
8. Starting with the corner nearest the gel clip retainer, attach the right
casting to the left casting with screws (22). Do the right screws
first, then the middle screws, then the left screws.
9. Install the iris slot cover (20) onto the barrel assembly with screws
(21).
10. With the colored dot on the lens facing out the barrel, slide the lens
holder assembly (or assemblies, if Zoom) into the lens holder track
inside the barrel. The assembly should slide smoothly in the track.
11. Insert light baffle strip (19) through front of barrel assembly and
through hole in lens holder assembly. Slide strip (19) through
supports in front of fixture and install screw (15), spring (24), washer
(23), and knob (4).
12. Attach the lamp burner (3) to the barrel assembly with the knurled
head screw.
13. Attach yoke (10) to barrel assembly with bolts (12) and washers (14).
Attach yoke knob (11) with bolt (13) and washer (14). Tighten bolts
(12) to secure yoke to fixture.
15

Advertisement

loading
Need help?

Need help?

Do you have a question about the Source Four jr Zoom and is the answer not in the manual?

This manual is also suitable for:

Source four jr