Table of Contents
Advertisement
Stitch Width Safety
using a straight stitch needle plate or a straight stitch presser
foot. The stitch width will be limited to zero for all stitches
to prevent damage to the needle, presser foot and needle
plate. This setting is saved when the machine is turned off.
A pop-up message reminds you of the setting when you
turn on the machine. Close the pop-up message by pressing
OK.
Free Motion Floating
To sew in free motion with the included Embroidery/
The drop feed teeth recommendation will be activated. The
setting remains when the machine is turned off. A pop-up
reminds you of the setting when you turn on the machine.
Close the pop-up message by pressing OK.
Note: You cannot set the machine in Free Motion Floating Mode if
Free Motion Spring Action is activated or vice versa.
When you are sewing free motion in low speed the foot will
raise and lower with each stitch to hold the fabric on the
stitch plate while the stitch is being formed. When sewing
The feed teeth must be lowered and the fabric is moved
manually. All stitches can be sewn in free motion mode.
Free Motion Spring Action
Action presser feet, you need to set the machine in
recommendation will be activated. The setting remains when
the machine is turned off. A pop-up message reminds you
of the setting when you turn on the machine. Close the
pop-up message by pressing OK.
up and down movement of the needle with help of the
spring and the arm on the presser foot. The feed teeth
must be lowered and the fabric is moved manually. It is
presser feet that are only intended for straight stitch sewing.
Pivot height
of the presser foot pivot position. The pivot position can be
raised or lowered in 15 steps by pressing the left/right arrow
buttons.
with the needle as you are stitching. Lowering the pivot height
will reduce the space between the presser foot and the fabric
and eliminate the skipped stitches.
Note: Be careful not to reduce the pivot height too much. The fabric
must still move freely under the presser foot.
Operating the machine
Buttonhole balance
you select stitch 1:30, the columns in the buttonhole stitch will
be sewn in different directions. On some fabrics this may cause
the columns to appear with different density. Use the left/right
buttons to balance the density between -7 and 7. The changes
only affect the selected stitch. If another stitch is selected or
the same stitch is selected again, the value is reset to the default
value.
Audible Alarm
Turns on or off all alarm sounds of the machine. Default setting
is on. This setting is saved even if the machine is turned off.
Contrast
Adjust the contrast of the GraphicDisplay by using the left/right
of 1. The setting is stored even when the machine is turned off.
Language
Use the left/right arrow buttons to change the language of all
text in your machine. The language setting is saved even if the
machine is turned off.
Software Version
The software version currently loaded for the sewing machine is
displayed.
2
33
Hide quick links:
Advertisement
Table of Contents
