Vega VEGASWING 51 Operating Instructions Manual page 12

4 Mounting
Inflowing medium
Flows
12
marking on the hexagon of VEGASWING 51. With this, you can check
the position of the tuning fork when screwing it in. When the hexagon
touches the seal, the thread can still be turned by approx. half a turn.
This is sufficient to reach the recommended installation position.
In adhesive and viscous products, the surfaces of the tuning fork
should protrude into the vessel to avoid buildup. Therefore sockets for
flanges and mountings bosses should not exceed a certain length.
Fig. 6: Adhesive products
If VEGASWING 51 is mounted in the filling stream, unwanted false
measurement signals can be generated. For this reason, mount
VEGASWING 51 at a position in the vessel where no disturbances, e.
g. from filling openings, agitators, etc., can occur.
To minimise flow resistance caused by the tuning fork, VEGASWING
51 should be mounted in such a way that the surfaces of the blades
are parallel to the product movement.
VEGASWING 51 • - contactless electronic switch
30mm
3
(1 / ")
16