Table of Contents
Advertisement
AM8010 Precision Thermometer User's Guide
4. To remove the sensor, just do the reverse of the above
procedure: turn the plug locking ring counter clock-wise, until
it is free, then pull out the plug.
4.5 Power On/Off Control
The power switch is on the top panel of AM8010. It is marked with
"OFF/ON" text. Users can follow the sign to turn the meter on/off.
4.6 Display of Measurement Results
The temperature measurement results are displayed on the LCD
screen. There are four lines of information as shown in Figure 3-1.
The main information is temperature in Celsius (C), Fahrenheit (F)
and sensor resistance (OHM). The other information includes
sensor type, USB connection status, battery low status and no
sensor indications.
The first line is the status information line. The second, third and
fourth line shows the measured data, which are temperature or
sensor resistance.
As shown Figure 3-1, the top line is the status information line. The
information includes：
1. Status sign. It is a flashing dot at the upper left corner. It
should flash under normal conditions.
2. Main measurement parameter. It is located just to the right of
the status sign. It should be either "t =" or "Rt =" which
means the second line information is temperature ("t=") or
sensor resistance ("Rt="). The information of the second line
can be changed by users. The details are shown in "4.7
Touchpad Operation".
3. USB status. When AM8010 is connected to a computer's
USB interface，"USB" will show up near the center of the
first line.
4. Sensor type. Two types of sensor, "IPRT" or "PRT", are
supported by AM8010. They are displayed as "IPRT" or
"PRT" on the LCD near the end of the first line. Users can
Rev. 201609V3
8/30
Advertisement
Table of Contents
