Table of Contents
Advertisement
AM8010 Precision Thermometer User's Guide
3. Power on AM8010. If a sensor is connected to AM8010，the
LCD should display the measurement reading. See the
following figure as an example. If no sensor is connected
users can still set parameters of a sensor.
4. Press and hold
right corner of LCD should show "MENU".
Then hold the
time. AM8010 should enter into adjustment program.
5. The following will be displayed on LCD after step 4. If no
adjustment or setting is needed, press
the highlight line to"EXIT" and then press
AM8010 will go back to measurement mode.
SENSOR SETTING
6. Move the highlight line to "SENSOR SETTING" and press
key to adjust sensor's settings. The following will be
displayed：
Rev. 201609V3
MENU
key for more than 3 seconds，the bottom
MENU
key and also press the
* MAIN MENU
EXIT
Enter = Yes
key at the same
or
key to move
key，
17/30
Advertisement
Table of Contents
