Table of Contents
Advertisement
AM8010 Precision Thermometer User's Guide
configure the sensor type by following the procedures that are
detailed in Chapter 6 "Sensor Parameter Input/Adjustment".
"IPRT" is defined as a 100
coefficient α=0.00385. "PRT" is defined as a 100
SPRT/PRT with temperature coefficient α=0.003925
(W
≥1.11807).
Ga
5. "NO SENSOR" status. "NO SENSOR" will be displayed
when no sensor is connected to AM8010.
6. "LOW BAT" status. "LOW BAT" is displayed when the
batteries are low in power.
The second line shows the measured results with larger fonts to
help users to focus on the key readings. The information of second,
third and fourth line can be scrolled up or down based on the user's
preference.
4.7 Touchpad Operation
There are four touch keys on AM8010 front panel. These touch
keys are used for scrolling up/down measurement data, or for
sensor parameter adjustment and calibrations.
Note: These keys are not mechanical push buttons. They are
only sensitive to finger touch.
When the meter is set to Measurement Mode,
to select the measured readings in Celsius (C), Fahrenheit (F)
or sensor resistance (OHM).
MENU
and
keys can be used for sensor type selection and sensor
parameter adjustment. These two keys are also used in
Calibration Mode (see Chapter 6).
Rev. 201609V3
sensor with temperature
Ω
Ω
and
are
9/30
Advertisement
Table of Contents
