Power With External Adapter And Usb; Sensor Connection - AccuMac AM8010 User Manual

AM8010 Precision Thermometer User's Guide

4.3 Power with External Adapter and USB

An AC/DC adapter (AC 100V ~ 240V input, DC5V output) can be
used to power AM8010.
The advantage of using the adapter is that the backlight of the LCD
display will be turned on and it is suitable for dim light conditions.
The connection procedures of the AC/DC adapter are as follows:
1. Connect USB A side to the adapter USB socket.
2. Connect USB mini-B side to "USB" connector of AM8010.
3. Plug the adapter to AC 100V ~ 240V power point. Switch on
the AC power.
4. If AM8010 is not powered on, switch it on. If AM8010 is
already powered by batteries and the power switch is on, the
backlight of LCD should illuminate.
5. The USB cable can be unplugged anytime. If AM8010 is
powered by batteries, functionality will continue.
AM8010 can be connected to a computer with the USB interface. In
this case the computer is the power source for AM8010.

4.4 Sensor Connection

PRT Sensors can be connected to the AM8010 "SENSOR" socket
with a 5-pin connector that is provided in this package. Connecting
steps are as follows:
1. Align the notch of sensor plug to the notch of "SENSOR"
socket.
2. Push in the sensor plug. At this moment, do not turn the knob.
Turning the sensor connector can cause damage of the socket
and plug.
3. After the plug is fully pushed in, turn the locking ring of the
plug clock-wise until it is fully tightened.
Rev. 201609V3 7/30