Table of Contents
Advertisement
6.
Installation
Securing to the wall
Installation must conform with all local Building, Water or Gas Regulations or using AS5601.
A heavy load will be applied to the wall on which the water heater is mounted. If the strength of the
wall is not sufficient, reinforcement will be necessary.
• Mount water heater in a vertical position with flue facing upwards
• Be sure to mount the water heater on an upright wall.
Item
Caution
1. Determine position of the unit.
2. Place unit on wall and mark position of fixings.
3. Remove unit and drill holes for fixings.
4. Mount unit and tighten fixings.
(Note: fixings should be sufficient to support the
weight of the unit).
• Make sure the unit is installed securely so that it will
not fall or move due to vibrations.
• Ensure water heater is firmly fixed to the structure.
Check
• When installing with bare hands,
take caution to not inflict injury.
• Be careful not to hit electrical
wiring, gas, or water piping while
drilling holes.
Illustration
Location of drill hole
Mounting bracket
(upper)
Location of drill hole
Fixing Screw
Insulation material
5mm or more
Building
(Covered with metal
wooden screw)
5mm or more
Min: 25mm
57
Hide quick links:
Advertisement
Table of Contents
