Bosch KM3211WH Installation & Owners Manual page 25

Approximate hot water conditions
37 38 39 40 41 42 43 44 45 46 47 48 50 55 60 65 70 75 80
Upper limit (maximum temperature) for temperature adjustment can be set using the remote controller RCM3211.
Washing
Shower, hot water supply, etc.
dishes, etc.
• Hot water temperatures are approximations, and may differ from actual temperatures depending
on external factors, such as the season and length of piping involved.
• When low temperatures are set (for washing dishes, etc.), if the ambient water temperature is
already quite high, it may be difficult to ensure the resultant water temperature is as per the
setting.
• When the hot water temperature is adjusted using thermostat-controlled water mixing valves, set
the temperature on the remote controller to about 10°C higher than that required to ensure the
appropriate temperature.
When setting high temperatures (60 - 80°C);
When setting high temperatures (60 - 80°C);
• When a high temperature is set, the readout on the
right is shown.
• Please check the temperature displayed before using
any hot water.
Be especially careful using any hot water after any
previous setting of between 60 - 80°C.
Please switch to the priority setting if the temperature
cannot be adjusted.
• If the power switch on the remote controller is turned "on", the
remote controller has priority in adjusting the temperature.
• When the temperature can be adjusted (console has priority), the
display screen is shown as per right.
• If the temperature cannot be adjusted, turn the power switch to
"off", and then turn it "on" again.
Hot water supply, etc.
Priority
Burner on
(Eg.: 60°C)
P20 and 21
High temperature
Temperature
display flashes for
Here
about 10 seconds
to indicate high
temperature.
Here
Priority
Burner on
(Eg.: 40°C)
25