Svp Rear Panel - Hitachi G800 Hardware Reference Manual

2
3

SVP rear panel

The only ports used on the rear panel of the physical SVP are the power socket and the
four LAN ports.
1
2
Note: After the Initial Startup Wizard is run, the SVP can be used in non-
bridge mode. In this mode, the cables can be removed from SVP ports LAN3
and LAN4 and attached to switches. For more information, contact customer
support.
Hitachi Virtual Storage Platform G800 Hardware Reference Guide
Number
Number
Chapter 6: Service processor
Description
LAN card 1
■
Hard drive
■
System standby power
■
Reset button.
Power button. Applies power to or
removes power from the SVP.
Description
Power socket. Attach the power cable
supplied with the SVP.
Four LAN ports arranged as follows:
LAN3 LAN4
LAN1 LAN2
These ports connect to your IP network,
the management console PC, and the user
LAN port on each storage system
controller.
SVP rear panel
60