Yamaha SXV70ERG Supplementary Service Manual page 53

STEERING
4. Install:
S Relay rod 1
NOTE:
Make sure that the end of the relay rod with the
indentation a is connected to the relay arm.
CAUTION:
Always use new cotter pins.
Nut (relay rod):
35 Nm (3.5 mSkg, 25 ftSlb)
5. Adjust:
S Skis
Adjustment steps:
S Temporarily install the handlebar.
S Hold the handlebar straight and check that the
skis are at right angles to the handlebar.
S Loosen the locknuts (relay rod) 1 .
S Position the skis parallel in the riding direction.
S With the skis in this position, turn the relay rod
2 in either direction until the handlebars at
right angles with respect to the direction of
movement.
Turning the relay
rod in direction
Turning the relay
rod in direction
S Tighten the locknuts (relay rod) 1 .
Locknut (relay rod):
25 Nm (2.5 mSkg, 18 ftSlb)
LOCTITE
–47–
CHAS
Turning the handle-
a
bar in direction
Turning the handle-
b bar in direction

c
d