Yamaha SXV70ERG Supplementary Service Manual page 156

1 Clamp the fuel hose using the
frame directly attached clamp.
2 Clamp the oil hose using the
frame directly attached clamp.
3 Lay the fuel tank breather hose
along the steering gate.
4 Lay the oil tank breather hose
along the steering gate.
5 Do not let the tail light lead inter-
fere with the frame edge.
6 Hide the tail light lead coupler in
the instrument panel and route
on the front side of frame clamp.
7 Clamp so that the oil tank cap
and oil tank breather hose do
not interfere with each other.
Band them beside the instru-
ment panel attaching bolt.
8 Make sure to pass the tail light
lead between the fuel tank and
panel without being caught and
secure the lead in the groove of
fuel tank bottom surface using
the adhesive tape (at 3 posi-
tions).
9 50 mm (1.97 in)
To tail light unit
10
Adhesive tape
11
Pass the fuel tank breather hose
12
through the holder.
Fuel sender coupler
13
Oil level gauge coupler
14
Ground lead
15
Attach the hexagon bolt to the
16
Y.P.V.S. bracket.
Attach the clip with its pawl di-
17
rected downward.
Insert the fuel tank breather
18
hose to the end.
CABLE ROUTING
–150–
SPEC