Yamaha SXV70ERG Supplementary Service Manual page 152

CABLE ROUTING
1 Thermo sensor
2 Ignition coil coupler
3 T.O.R.S. coupler
4 CDI magneto coupler cover
5 Clamp the CDI magneto cou-
pler, harness and T.P.S. lead.
6 Pass the starter (choke) throttle
and oil pump cables through
the holder of intake silencer.
7 T.P.S. coupler
8 Clamp the wire harness. (For
model with reverse)
Route the main switch coupler
9
under the fuel tank breather
hose and oil tank breather hose
and then it should be hidden by
the instrument panel.
Route the main switch harness
10
behind the instrument panel at-
taching screw.
Pass the parking brake cable
11
under the oil tank breather hose.
Main switch
12
First, the main switch lead shall
be looped, and then route it ac-
cordingly.
Starter (choke) lever
13
Brake hose
14
Throttle cable
15
Oil pump cable
16
Thumb warmer resistor
17
Grip warmer resistance
18
Oil level gauge
19
Variable resistor coupler
20
Speed sensor
21
Coolant hose
22
Carburetor heating lever
23
Fold back the clamp and se-
24
cure it.
Drive V-belt guard bracket
25
Clamp the headlight harness.
26
CABLE ROUTING
–146–
SPEC