Evb Default-Manager - HPE 5920 Series Command Reference Manual

Field
Link
Duplex
Cause
Related commands
reset counters interface

evb default-manager

Use evb default-manager to specify the default VSI manager.
Use undo evb default-manager to restore the default.
Syntax
evb default-manager { { ip ip-address | ipv6 ipv6-address | name name } [ port port-number ] |
local-server }
undo evb default-manager
Default
The default VSI manager is not specified.
Views
System view
Predefined user roles
network-admin
Parameters
ip ip-address: Specifies the IPv4 address of the default VSI manager.
ipv6 ipv6-address: Specifies the IPv6 address of the default VSI manager.
name name: Specifies the name of the default VSI manager, a case-insensitive string of 1 to 127
characters.
port port-number: Specifies the port number of the default VSI manager, in the range of 0 to 65535.
The default port number is 8080.
local-server: Specifies the device as the default VSI manager.
Description
Physical connection status of an interface:
•
UP—The interface is physically up.
•
DOWN—The interface is physically down.
•
ADM—The interface was shut down by using the shutdown
command. Bring it up by using the undo shutdown
command.
•
Stby—A standby interface.
Duplex mode of an interface:
•
(a)/A—Autonegotiation.
•
H—Half-duplex.
•
F—Full-duplex.
Causes of a DOWN link:
•
Administratively—The interface was shut down by executing
the shutdown command. To restore the physical state of the
interface, use the undo shutdown command.
•
Not connected—No physical connection because of absence
or failure of network cables.
12