Cleaning And Sanitizing - Follett 7UC100A Installation, Operation And Service Manual

Cleaning and Sanitizing –––––––––––––––––––––––––––––––––––––––––––––
IMPORTANT! Prior to cleaning and sanitizing, the dispenser must be moved
forward at least 4" (102 mm) to allow access to the Bin Lid Cleaning Spout
(Fig . 8 .1) .
CAUTION!
Place the dispenser in Maintenance Mode prior to servicing or
cleaning the ice machine. See Maintenance/Cleaning Mode on
page 8.
Required Supplies
§ (3) x 7 ounce SafeCLEAN™ environmentally-friendly icemaker cleaner
packets
§ Nu-Calgon IMS-II sanitizer
§ Funnel
§ Bucket
Cleaning: Icemaker and Dispenser
1 . Dispense all the ice out of the unit, then see Accessing Internal Components on page 8.
2 . Press and hold maintenance/clean switch until
Mode .
3 . Remove (unscrew) chrome ice dispense chute .
4 . Remove drip tray .
5 . Remove (2) screws located behind the drip tray .
6 . Move front panel and place on top or beside unit .
7 . Remove plug cap from the end of drain tube and lower tube to drain water into bucket .
8 . After the system has been drained of water replace plug cap in drain tube .
9 . Secure tube in holder .
10 . Remove cap from bin lid cover .
11 . Screw cap onto ice discharge chute .
12 . Mix SafeCLEAN Ice Machine Cleaner, (3) x 7 ounce packets, with three gallons (11 .4 L) of water .
13 . Pour cleaning solution into bin lid access spout until solution reaches the spout neck .
14 . Allow the solution to remain in unit for 15 minutes .
15 . While machine is cleaning, remove top and right side panel to access and clean air-cooled condenser .
16 . Drain system by lowering drain tube into bucket .
17 . Secure drain tube into holder .
18 . Fill one time with potable water and drain with fill tube . Secure drain tube .
Sanitizing: Icemaker and Dispenser
1 . Mix a sanitizing solution of 2 .5 gallons (9 .5 L) of water and 4 ounces (118 ml) of Nu-Calgon* IMS-II
sanitizer .
2 . Pour sanitizing solution into bin lid access spout until solution reaches the spout neck .
3 . Allow the solution to remain in unit for 5 minutes .
4 . Drain system by lowering drain tube .
5 . Secure drain tube into holder .
6 . Fill and drain three times with potable water .
7 .
Place a bucket under the dispense chute and remove cap .
Caution: Some sanitizing solution will remain and drain out when cap is removed . Reposition cap on bin lid spout .
8 . Reinstall front panel, ice dispense chute, and drip tray .
9 . Press and hold maintenance/clean switch to exit Maintenance Mode .
* Calgon is a licensed trade name .
10 Undercounter Dispenser and Icemaker 7UC100A/7UD100A
Fig . 8
displays in the user interface to enter Maintenance
1