Specific Safety Rules; Specifications; Additional Safety Rules - AEG RT 1350 E Instructions Manual

Refer 12/27/04 5:04 PM

SPECIFIC SAFETY RULES

Hold tool by insulated gripping surfaces when
performing an operation where the cutting tool may
contacthidden wiring or its cord. Contact with a "live" wire
will make exposed metal parts of the tool "live" and shock the
operator.

ADDITIONAL SAFETY RULES

Know your power tool. Read operator's manual
■
carefully. Learn its applications and limitations, as
well as the specific potential hazards related to this
tool. Following this rule will reduce the risk of electric
shock, fire, or serious injury.
Always wear safety glasses. Everyday eyeglasses
■
have only impact-resistant lenses; they are NOT
safety glasses. Following this rule will reduce the risk of
serious personal injury.
Protect your lungs. Wear a face or dust mask if the
■
operation is dusty. Following this rule will reduce the
risk of serious personal injury.
Protect your hearing. Wear hearing protection during
■
extended periods of operation. Following this rule will
reduce the risk of serious personal injury.
Inspect tool cords periodically and, if damaged, have
■
repaired at your nearest Factory Service Center or
other Authorized Service Organization. Constantly
stay aware of cord location. Following this rule will
reduce the risk of electric shock or fire.
Check damaged parts. Before further use of the tool,
■
a guard or other part that is damaged should be
carefully checked to determine that it will operate
properly and perform its intended function. Check for
alignment of moving parts, binding of moving parts,
breakage of par ts, mounting, and any other
conditions that may affect its operation. A guard or
other part that is damaged should be properly
repaired or replaced by an authorized service center.
Following this rule will reduce the risk of shock, fire, or
serious injury.
Do not abuse cord. Never carry the tool by the cord or
■
yank it to disconnect it from the receptacle. Keep
cord away from heat, oil, and sharp edges. Following
this rule will reduce the risk of electric shock or fire.
Inspect for and remove all nails from lumber before
■
routing. Following this rule will reduce the risk of serious
personal injury.
Drugs, alcohol, medication. Do not operate tool while
■
under the influence of drugs, alcohol, or any
medication. Following this rule will reduce the risk of
electric shock, fire, or serious personal injury.
Save these instructions. Refer to them frequently and
■
use them to instruct others who may use this tool. If
you loan someone this tool, loan them these
instructions also.
Page A6
Your risk from these exposures varies, depending on how
often you do this type of work. To reduce your exposure to
these chemicals: work in a well ventilated area, and work with
approved safety equipment, such as those dust masks that
are specially designed to filter out microscopic particles.

SPECIFICATIONS

Voltage
No load speed
Input power
Plunge depth
Collet size
Net weight
- 7 -
WARNING:
Some dust created by power sanding, sawing,
grinding, drilling, and other construction activities
contains chemicals known to cause cancer, birth
defects or other reproductive harm. Some examples
of these chemicals are:
• lead from lead-based paints,
• crystalline silica from bricks and cement and
other masonry products, and
• arsenic and chromium from chemicallytreated
lumber.
: 220-240V ~ / 50-60Hz
-1
: 15000 - 30000min
: 1350W
: 50mm
: 1/2" or 1/4"
4.01kg