Subscribe to Our Youtube Channel
Related Manuals for BLAUBERG KOMFORT L350
Summary of Contents for BLAUBERG KOMFORT L350
- Page 1 HEAT RECOVERY AIR HANDLING UNIT KOMFORT L OPERATION MANUAL KOMFORT_L v2(2)_EN.indd 1 07.08.2015 15:03:44...
-
Page 2: Table Of Contents
KOMFORT L www.blaubergventilatoren.de CONTENTS Introduction General Safety regulations Transportation and storage regulations Manufacturer's warranty Design Operation logic Delivery set Technical data Mounting Condensate drainage Connection to power mains Unit control Technical maintenance Troubleshooting Acceptance certificate Connection certificate Warranty card KOMFORT_L v2(2)_EN.indd 2 07.08.2015 15:03:45... -
Page 3: Introduction
KOMFORT L www.blaubergventilatoren.de BLAUBERG Ventilatoren GmbH Company is happy to offer your attention a The unit complies with the requirements according to the EU norms heat recovery air handling unit KOMFORT L. and directives, to the relevant EU-Low Voltage Equipment Directives, EU- Directives on Electromagnetic Compatibility. -
Page 4: Design
If the heat exchanger freezing becomes imminent a thermostat relay interrupts the supply fan circuit. After KOMFORT L1200 / L2200 KOMFORT L350 / L500 / L530 / L600 Extract lter Control unit... -
Page 5: Technical Data
88 up to 87 Heat exchanger type cross-flow Heat exchanger material aluminium Table 2. Overall dimensions Dimensions [mm] Model KOMFORT L350 KOMFORT L500 KOMFORT L530 KOMFORT L600 KOMFORT L1200 KOMFORT L2200 1000 1050 Fig. 2. Overall dimensions Table 3. Accessories... -
Page 6: Mounting
KOMFORT L www.blaubergventilatoren.de MOUNTING WARNING Safety precautions: The unit must be mounted to a rigid and stable structure. The unit must be suspended using anchor bolts. Make sure that the base structure is capable of sustaining the unit weight. The unit mounting is allowed only after power cut-off and full stop of the rotating parts. Restrictions: Do not operate the unit beyond the determined temperatures, in aggressive and in explosive medias. -
Page 7: Condensate Drainage
While laying the hoses provide the slope downward min 3 %. KOMFORT L350 Fill the system with water prior to connecting it to power supply. The U-trap must always be filled with water to maintain free flow of condensate. -
Page 8: Connection To Power Mains
Cut power supply to the unit off by turning the automatic electric switch QF to OFF position prior to any operations. Take steps to prevent activation of the automatic switch before finishing all the operations. KOMFORT L350 / L500 / L530 /L600 KOMFORT L1200 / L2200 Control unit... -
Page 9: Unit Control
KOMFORT L www.blaubergventilatoren.de UNIT CONTROL The step control of the unit air flow is performed with the speed switch. Make sure to install the switch in a convenient location. The units are equipped with the CDP 3/5 speed controller. It is factory- connected to the unit terminal block in compliance with the Wiring diagram on page 7. -
Page 10: Troubleshooting
KOMFORT L www.blaubergventilatoren.de TROUBLESHOOTING Fault Possible reason Troubleshooting Connect the unit to power supply. Troubleshoot the No power supply or wrong connection to power mains. connection error. The fans do not operate The motor is jammed, the impeller blades are soiled. Remove the motor jam, clean the impeller blades. -
Page 11: Acceptance Certificate
KOMFORT L www.blaubergventilatoren.de ACCEPTANCE CERTIFICATE The air handling unit with heat recovery KOMFORT L350 KOMFORT L600 KOMFORT L500 KOMFORT L1200 KOMFORT L530 KOMFORT L2200 is recognized as serviceable. The unit complies with the requirements according to the EU norms and directives, to the relevant EU-Low Voltage Equipment Directives, EU-Directives on Electromagnetic Compatibility. - Page 12 www.blaubergventilatoren.de KOMFORT L v.2(2) / EN KOMFORT_L v2(2)_EN.indd 12 07.08.2015 15:03:49...
Need help?
Do you have a question about the KOMFORT L350 and is the answer not in the manual?
Questions and answers