Meta System MEGALINE 1250 RACK Instruction Manual page 40

Input
Power xxxx
Appar.Pow. xxxx
V RMS xxx
I RMS xxxx
Peak Current x
Frequency x
I Crest factor x
Power Fact x
Batteries
Voltage xx
Residual Cap. xxxx
xxxx
Discharge count
Usage xxxx
Cal.dd/mm/yyhh:mm
Ext. KB units xx
Ext Chargers xx
History Data
UPS Ontime xxxxx
BoosterOnTime xxxx
DrainedOut N. xxxx
Booster Int. xxxx
Bypass Interv. xxxx
OverheatCount xxxx
Power
Appar. Pow.
➧
V RMS
I RMS
Peak Current
Frequency
I Crest factor
Power Fact
Voltage
Residual Cap.
➧
Discharge
Count
Usage
Cal..
Ext. KB units
Ext Chargers
UPS Ontime
➧
BoosterOnTime
DrainedOut N.
Booster Int.
Bypass Interv
OverheatCount
Indicates the power received from mains (W)
Indicates the apparent power received from mains (VA)
Indicates the effective voltage (V RMS) at the UPS input
Indicates the effective current (A RMS) received from
mains
Indicates the peak current received from mains (A)
Indicates the frequency of the UPS input voltage (Hz)
Indicates the crest factor, calculated as the ratio between
the peak value and the effective value of the current
received from mains
Indicates the power factor applied to mains
Indicates the voltage at the terminals of the battery kits (V)
Indicates the percentage of battery charge
Indicates the number of battery discharge cycles
Hours of operation on battery power
Indicates the date (day / month / year) and the time
(hours / minutes) of the last battery calibration
Indicates the number of external KBs fitted
Indicates the number of external battery chargers fitted
(the MetaSystem CB36)
Indicates the total number of hours of UPS operation
Indicates the number of hours of UPS operation in booster
mode (running on battery power)
Indicates the number of times the UPS has completely
discharged its batteries.
Number of times booster mode has intervened (running on
battery power)
Number of times the by-pass has intervened (refer to
Config.UPS / By-pass menu)
Number of times the thermal protection has been triggered
(due to excessive load, for example)
40
4 - Customising the UPS operating mode