Table of Contents
Advertisement
If you disconnect or replace the battery
and your vehicle has an automatic
transmission, transmission must relearn
its adaptive strategy. Because of this, the
transmission may shift firmly when first
driven. This is normal operation while the
transmission fully updates its operation to
optimum shift feel.
Remove and Reinstall the Battery
To disconnect or remove the battery, do
the following:
1.
Apply the parking brake and switch the
ignition off.
2. Switch all electrical equipment off, for
example lights and radio.
3. Wait a minimum of two minutes before
disconnecting the battery.
4. Disconnect the negative battery cable
terminal first.
5. Disconnect the positive battery cable
terminal last.
6. Remove the battery securing clamp.
7.
Remove the battery.
8. Install in the reverse order.
*
The engine management system has a
power hold function and remains powered
for a period after you switch the ignition
off. This is to allow diagnostic and adaptive
tables to be stored. Disconnecting the
battery without waiting can cause damage
not covered by the vehicle Warranty.
**
Before reconnecting the battery, make
sure the ignition remains switched off.
Note: If you only disconnect the negative
battery cable terminal, make sure it is
isolated or placed away from the battery
terminal to avoid un-intended connection
or arcing.
Note: Make sure the battery cable terminals
are fully tightened.
Mustang (CZG, CZY) Vehicles Built From: 02-05-2016, HR3J 19A321 AKA enGBR, First Printing
Maintenance
Note: If you disconnect or replace the
battery, you must reset the clock and the
pre-set radio stations once the battery is
reconnected.
Battery Disposal
E107998
Seek advice from your local authority
about recycling old batteries.
CHECKING THE WIPER
BLADES
*
E142463
Run the tip of your fingers over the edge of
**
the blade to check for roughness.
Clean the wiper blades with washer fluid
or water applied with a soft sponge or
cloth.
CHANGING THE WIPER
BLADES - LHD
1.
165
Make sure that you dispose of
old batteries in an
environmentally friendly way.
Pull the wiper blade and arm away
from the glass and press the locking
buttons together.
Advertisement
Table of Contents
Troubleshooting
