Ford Mustang 2017 Owner's Manual page 186

Note: If you experience any unusual
vibration, ride disturbance or noise while
driving, reduce your speed until you can
safely pull off to the side of the road to call
for roadside assistance. Note: Do not
proceed to the second stage of this
operation.
Second Stage: Checking Tire
Pressure
WARNINGS
If you are proceeding from the First
Stage: Re-inflating the Tire with
Sealing Compound and Air section
and have injected sealant in the tire and
the pressure is below 1.4 bar (20 psi),
continue to the next step.
The power plug may get hot after use
and should be handled carefully
while unplugging.
Check the air pressure of your tires as
follows:
E175983
1. Remove the valve cap from the tire
valve.
2. Firmly screw the air compressor hose
onto the valve stem by turning
clockwise.
3. Push and turn the dial clockwise to the
air position.
Mustang (CZG, CZY) Vehicles Built From: 02-05-2016, HR3J 19A321 AKA enGBR, First Printing
Wheels and Tires
4. If required, switch on the compressor
5. Unplug the hoses, re-install the valve
What to Do After the Tire has Been
Sealed
After using the kit to seal your tire, you will
need to replace the sealant canister. You
can obtain sealant canisters and spare
parts at an authorized Ford dealer. You can
dispose of empty sealant canisters at
home. However, you should dispose of
canisters still containing liquid sealant
through your local authorized Ford dealer
or tire dealer, or in accordance with local
waste disposal regulation.
Note: After you use the sealing compound,
the maximum vehicle speed is 80 km/h
(50 mph) and the maximum driving
distance is 200 km (120 mi). You should
inspect the sealed tire immediately.
You can check the tire pressure any time
within the 200 km (120 mi) by performing
the steps listed previously in the Second
Stage: Checking Tire Pressure procedure.
182
and adjust the tire to the
recommended inflation pressure
shown on the tire label located on the
driver's door or door jamb area. You
should check the tire pressure with the
compressor turned OFF in order to get
an accurate pressure reading.
cap on the tire and return the kit to the
stowage area.