Closing The Convertible Top - Ford Mustang 2017 Owner's Manual

Using the Tonneau Caps
Your convertible top also includes two
tonneau caps, one for each side of the
vehicle. These caps stow inside the trunk.
E174569
A. Leading edge.
B. Side edge.
After opening your convertible top, place
the tonneau caps between the top and
your vehicle trim moulding:
1. Insert A under the trim.
2. When A is under the trim cap, angle B
down so the edges slide under the
surrounding moulding and secure into
place between the trim edges.
3. Repeat Steps 1 and 2 on the opposite
side of the vehicle to install the second
tonneau cap.
CLOSING THE CONVERTIBLE
TOP
Closing the convertible top is a three-step
process: Remove both of the tonneau
caps, press the convertible top control to
close the top, and then close the latch.
Mustang (CZG, CZY) Vehicles Built From: 02-05-2016, HR3J 19A321 AKA enGBR, First Printing
Convertible Top
133
(If Equipped)
To remove the tonneau caps:
1. Slide B toward the center of the vehicle
to release the edges from the
surrounding trim.
2. Lift up on B, and then pull the piece
back to release A from the trim.
3. Repeat Steps 1 and 2 on the opposite
side of the vehicle.
4. Make sure you stow both pieces in the
trunk.
E179941
Note: The convertible top does not operate
unless the vehicle is stationary or traveling
under 4.8 km/h (3.0 mph). A chime sounds
and a warning message appears in the
instrument panel. When you slow down, the
top operates.
Note: You must remove the tonneau caps
before you are able to close the top or a
chime sounds and a warning message
appears in the instrument panel. Remove
and stow the caps, and then press the
convertible top control again.
Note: When you latch or unlatch the
convertible top, the audio system mutes
briefly. This allows the vehicle to optimize
the cabin s sound quality depending on the
position of the convertible top.