Electrical Installation; Important Notes; Mounting - Lenze MC-CAN2 Operating Instructions Manual

4

Electrical installation

4.1

Important notes

(
Stop!
Short circuit and static discharges
The printed circuit board and the standard device contain components which
are endangered in the case of short circuit or static discharge.
Possible consequences:
ƒ
Protective measures:
ƒ
ƒ
ƒ
ƒ
ƒ
)
Note!
For mounting the unit, the housing of the industrial PC has to be opened
(^ documentation for the standard device).
4.2

Mounting


BA_MC−Card EN 1.0
The printed circuit board or devices connected are destroyed.
For all operations on the printed circuit board, the latter as well as the
standard device have to be in a deenergised state. This in particular applies
to the connection/disconnection of the printed circuit board and the
connection/disconnection of connectors.
All persons handling printed circuit boards must regard ESD measures.
Connector contacts must not be touched.
Printed circuit boards must only be touched in contact−free places and must
only be placed on suitable bases (e. g. on ESD packaging or conductive
foamed material).
Printed circuit boards must only be transported and stored in ESD
packaging.
‚
LI N
S Y S K
S T 0
M C
M C S T 1
-P N -E T
H x S T 2
RJ RJ
SS SS -53 -53
81 81
A C
LI N T IV
K E
RJ RJ
SS SS -53 -53
81 81
L A
N P R S P
O F RJ RJ E E
SS SS -53 -53 D
IN 81 81
E T
ƒ
LI N
K
S Y S
S T 0
M C M C
-E T -P N S T 1
H x S T 2
RJ RJ
SS SS
-53 -53 81 81
A C
LI N T IV
K
RJ RJ E
SS SS
-53 -53 81 81
L A
P R N S P
O F RJ RJ E E
SS SS D
IN -53 -53 81 81
E T
l
Electrical installation
Important notes
4
MC−PNx−002
23