Table of Contents
Advertisement
Quick Links
Download this manual
See also:
System Manual
Advertisement
Table of Contents
Related Manuals for Lenze L-force Controls
Summary of Contents for Lenze L-force Controls
- Page 1 L-force Controls Manual (Software) PC based Automation Global Drive Control (GDC) Industrial PC as Gateway...
-
Page 2: Copyright
This manual applies to the Lenze »Global Drive Control« (»GDC«) as of version 4.10 (SP 4) Copyright © 2008 Lenze Drive Systems GmbH. All rights reserved. Imprint Lenze Drive Systems GmbH Postfach 10 13 52, 31763 Hameln, Germany Phone: ++49 (0)5154 / 82-0 Telefax: ++49 (0)5154 / 82-2111 E-mail: Lenze@Lenze.de... -
Page 3: Table Of Contents
Global Drive Control | Industrial PC as Gateway Inhalt Contents Safety instructions ..............About this Manual . -
Page 4: Safety Instructions
Global Drive Control | Industrial PC as Gateway Safety instructions Safety instructions Please observe the following safety instructions when you want to commission a controller or system using the »Global Drive Control«. Please read the documentation supplied with the controller / system components carefully before you start commissioning the devices with the »Global Drive Control«! The device documentation contains safety instructions which must be observed! -
Page 5: About This Manual
Global Drive Control | Industrial PC as Gateway About this Manual Conventions used About this Manual This Software Manual contains information about the Industrial PC(IPC) as gateway . Note! The Software Manual supplements the Mounting Instructions enclosed with the controller, the Hardware Manual, and the Software Manual for the controller. The Mounting Instructions contain safety information which must be observed! Conventions used This Software Manual uses the following conventions to distinguish between different... -
Page 6: Definition Of Notes Used
Global Drive Control | Industrial PC as Gateway About this Manual Definition of notes used Definition of notes used The following signal words and symbols are used in this Software Manual to indicate dangers and important information: Safety instructions Layout of the safety instructions: Pictograph and signal word! (characterise the type and severity of danger) Note... -
Page 7: Ipc As Gateway
Global Drive Control | Industrial PC as Gateway IPC as gateway Setting of the communication path IPC as gateway This chapter describes how to use the gateway function of an IPC to establish an online connection to a field device. The »Global Drive Control«... -
Page 8: Connect To Drive
Global Drive Control | Industrial PC as Gateway IPC as gateway Connect to drive To set the communication parameters, you must enter the following information about your configuration: Information Function IP address IP address of the IPC which serves as gateway for communication CAN interface Number of the CAN interface, to which the required field device is connected... -
Page 9: Remedy In Case Of Error
Global Drive Control | Industrial PC as Gateway IPC as gateway Connect to drive The parameters of the connected drive are read from the connected drive. 4.2.1 Remedy in case of error If no drive can be found, the »GDC« displays an error message: Proceed as follows to remove the error: –... -
Page 10: Online Mode Via Ipc Gateway Function
Global Drive Control | Industrial PC as Gateway IPC as gateway Connect to drive 4.2.2 Online mode via IPC gateway function After the parameters have been read in successfully, the drive is in online mode. The drive parameters are available in the »GDC«: In a separate window, the »GDC«... -
Page 11: Index
Global Drive Control | Industrial PC as Gateway Index Index Application notes Conventions used Copyright Copyright information E-Mail an Lenze Feedback an Lenze Imprint Layout of the safety instructions Liability Safety Safety instructions Trademarks 1.0 EN - 03/2008... -
Page 12: Your Opinion Is Important To Us
These Instructions were created to the best of our knowledge and belief to give you the best possible support for handling our product. If you have suggestions for improvement, please e-mail us to: feedback-docu@Lenze.de Thank you for your support. Your Lenze documentation team...