Use Of The Keypad Hmi - Eliwell EWCFW-08 User Manual

FWD/REV
Control
Selection
HMI LED Situation
4.2 USE OF THE
KEYPAD (HMI)
CHAPTER 4 - KEYPAD (HMI) OPERATION
FWD / REV
Forward
Figure 4.2 - Direction of rotation (FWD/REV) LEDs
Basic functions of the keys:
Starts the inverter via acceleration ramp.
Stops (disables) the inverter via deceleration ramp.
Also resets inverter after a fault has occurred.
Toggles the LED display between parameter number and its
value (number/value).
Increases the frequency, the parameter number or the
parameter value.
Decreases the frequency, the parameter number or the
parameter value.
Reverses the direction of motor rotation between Forward/
Reverse
Toggles between the LOCAL and REMOTE modes of
operation.
Performs the JOG function when pressed. Any DI programmed
for General Enable (if any) must be closed to enable the JOG
function.
The keypad is used for programming and operating the CFW-08,
allowing the following functions:
Indication of the inverter status and operation variables.
Fault indication and diagnostics.
Viewing and programming parameters.
Reverse
OFF
ON
Flashing
t
Forward
t
t
67