Table of Contents
Advertisement
ID-AL ChronoPlayer - User Guide V1.0
9.1 Assign a Device Number - #ID:xxx
It is possible to have several ChronoPlayers in the same installation communicating amongst themselves
and with a main device through the RS-232 serial link. In order to do this, a number has to be assigned to
each ChronoPlayer among 127 possible IDs, meaning that 127 ChronoPlayers can be used at the same time
(see the chapter RS-232 Serial Link Protocol).
Parameter Definition
#ID:xxx
Parameter Definition
#ID:023
If the line is missing, the factory setting value by default 001 is used, designating the player 001.
Note: Several players can have the same number. All the players with the same number execute the same
commands sent through the RS-232 link.
000 is a special case and cannot be used in the configuration file. When the code 000 is sent through the
serial link, it means that all the players execute the command sent, whatever the number identifying the
player.
9.2 Volume Setting - #VOLUME:xx
It is possible to define the volume to be used on startup. This volume can then be changed with the front
knob, with an RS-232 command, or with the infrared remote control.
The volume setting goes from 00 to 64, in 64 steps.
00 is the minimum volume (mute), and 64 is the maximum.
Parameter Definition
#VOLUME:xx
Parameter Definition
#VOLUME:18
If the line is missing, the last set value is used
9.3 Configuration of the Baud Rate of the RS-232 Serial Link -
#BAUDRATE:xxxxx
By default, the RS-232 serial link is at 19200 bauds in both directions. With this option, this value can be
modified.
Table 8: #ID parameter syntax
xxx: a number between 001 and 127.
Assign number 23 to the player.
Table 9: #VOLUME parameter syntax
xx: a value between 00 and 64.
The volume is set to 18 on startup.
Description
Example
Effect of the Defined Parameter
Description
Example
Effect of the Defined Parameter
-33-
© 2016, Waves System
Advertisement
Table of Contents
