Table of Contents
Advertisement
WIT-300H User Manual
Issue: 0.4C
To retrieve the CO call during a holding
Press [FLEX] (right key in navigation) + select {FLEX} button + [ OK ]
To hold a call and make a new call
After holding a call, each pressed key will be sent to the system directly (not pre-dial)
Condition
1. The Call must be answered before Hold can be initiated.
2. The WIT-300H will receive hold recalling after hold recall timer. At this time, WIP-Phone can
answer the ring by pressing Send button.
3. Only 1 call at a time may be placed on hold
4. IPECS will provide hold music to the held user during holding
5. When there are several held lines , the user can select the held line with pressing number ( [1]
or [2] or [3] ) or navigation UP/DOWN and [OK] .
5.3.5
Call Forward
Description
This feature provides a user the ability to forward calls under the certain condition. A user may forward a
call to a certain station, station group, MFIM or an external party.
The following call forward types are supported.
- Unconditional, Busy, No-answer, Busy/No answer, Off-net, No answer Off-net
Operation
In Idle State + Press [KTU] + select {Forward} + [ OK ] + Enter Forward Type + Enter Station Number
+ Press [ End ] (
)
This Document Contains proprietary information and may not be reproduced or copied without express
Written permission of a duly authorized representative of LG Electronics company
25
Date: 24/May/2005
Advertisement
Table of Contents
