Table of Contents
Advertisement
WIT-300H User Manual
Issue: 0.4C
MFIM IP.
IP address of MFIM.
MFIM Netmask.
Network mask value of MFIM.
6.5.6
key Lock
When you enable key lock, keypad will be lock automatically on an idle screen after the key lock time.
Without any key requesting. You can set the key lock time as diable, 10sec, 30sec or 1minute. If you want
to unlock your phone keypad, press [OK] twice. But, if you enabled key lock before, your phone keypad
will be unlock and then after key lock time the keypad will be lock up again automatically.
6.5.7
Dialing Rule
You can set CO Access code previously. This CO access code in Dialing rule will be attached to dialing in
Recent call, Phonebook, and Call History except dialing in idle state. We check the number in recent call,
Phonebook, Call History and if the length of dialing number is more than 4 except CO access code, CO
access code will be added to the dialing number.
Note:
1. To distinguish between 4 digit CO and 4 digit ICM, we leave the dial number added CO
access code in recent call.
6.5.8
User Dictionary
You can add a word to the T9 dictionary. This word can be found in T9 editing by pressing '*' key
Note:
1. This editing mode support Abc, ABC, abc.
6.6
Phone Information [Menu + 6]
This Document Contains proprietary information and may not be reproduced or copied without express
Written permission of a duly authorized representative of LG Electronics company
47
Date: 24/May/2005
Advertisement
Table of Contents
